Mass Air Flow Sensor - Help

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 17, 2016
Threads
5
Messages
14
Location
Dallas, TX
My check engine light has been on for a few weeks. I took my 1996 LC to Autozone for a diagnostic and was told it was the Mass Air Flow Sensor. Before I buy a new part, assuming the MAF has not gone bad, is it possible the MAF tripped the engine light due to a dirty air filter or the MAF being dirty?

The car drives as normal, though the fuel consumption seems to have increased.

Thanks!
 
If you have a chance to pull the code again id verify exactly which it is.

They do make a MAF cleaner for the sensor inside. Wouldn't hurt to try and wont cost much. Unplug batt to reset CEL and see if it stays off after cleaning.
 
If you have a chance to pull the code again id verify exactly which it is.

They do make a MAF cleaner for the sensor inside. Wouldn't hurt to try and wont cost much. Unplug batt to reset CEL and see if it stays off after cleaning.



The code is P0171. According to the guy at AutoZone it means it's running too lean. Any suggestions?
 
Can't that also mean and oxygen sensor failure?
 
P0171 means that the SYSTEM is lean, not that the engine is running lean. The difference being that the values used by the ECU from the MAF sensor requires enrichment to satisfy the O2 sensor.

So it could be a dirty MAF sensor, or a bad electrical connection at the sensor, both which will produce a lower signal than it's supposed to.

It could also indicate a fueling issue such as a failing fuel pump of restricted fuel filter, both would supply less fuel.

It could be an O2 sensor as well but the plugs would be black from running rich.

So start with the easy stuff and go from there.
 
Thank you, everyone. I reset the CEL after cleaning the MAF with MAF cleaner. Hopefully that did the trick. If not, I'll run down the other suggested items.
 
I also found that I cleared all codes and cleared the "settings" by unhooking my battery for the day (I was working on it) and now my truck runs MUCH better and gets better mileage because it has cleared out all the crap it has accumulated for how it has "learned" my driving style.

I recommend clearing all your settings once a year to keep it "fresh"
 
Back
Top Bottom