LX470 AHC height control accumulator bleed screw part number

[latetotheparty]

Is this bleed screw available, and if so, can someone please provide a part number?

I compared the bleeder for the height control accumulator (the cylinder) to new bleeders I purchased for the four actuators/accumulators at the wheels (the globes), and they are not the same part.

(this is a 2006 LX470, in case that matters)

Thank you all in advance.

 

[latetotheparty]

And if the actual bleeder can't be purchased, can anyone confirm a suitable replacement? Thanks again in advance.

 

[Jack90210]

EDIT: just saw that you stated the plug for the accumulator is different than the ones for the globes. Imma look it up

2nd EDIT: I don't see it listed on the PartSouq fiche.

 

[Snow Wagon]

Hello latetotheparty,
Based on my experience, on earlier LX470s (1998 to 2005), I'm 99% sure the same part number can be used for all 5 bleeders (49189-60010).
I've swapped all bleeders on a 2000 and a 2005 LX470 (due to corrosion...) and I only buy / stock 1 bleeder.

Cruser Patch sells a set of 5 and indicates all 5 bleeders are the same for 1998 to 2007.

OEM Toyota Land Cruiser LX450D LX460 LX470 LX570 AHC Fluid Bleeder Scr

Sold in sets of five (5x) The bleeder screws on old AHC hydraulic suspension systems sometimes get clogged and need to be replaced. There are five total on a 100 Series Land Cruiser (2006/2007) or LX470 (1998-2007). Four accumulator (globe) bleeders and one on the HCA (height control...

www.cruiserpatch.com

So, while the current bleeder on your accumulator might be different than the bleeders on your globes, I believe the thread pattern is the same.

Good luck.
Tom