LX 450 P/S problem

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Bodean

Hot Damn
Joined
Dec 20, 2004
Threads
618
Messages
11,684
Location
Brandon, MS
Ok this problem just started. It's a 96 LX450 with 181k on it. In a heavy braking situation I am losing all power steering. Rev the motor up and it comes back. I checked the level and actually sucked out all of the old fluid and repalced with Lucas power steering fluid and conditioner. Thought it was fine and drove it yesterday and it happened again. I'm at a loss. Braking shouldn't affect power steering. This is not a hydroboost system.
 
80 series power steering should have AFT, not power steering fluid. Probably not causing the loss of assist, tho. Is the assist good at idle with the truck not moving?
 
Yes it's fine at idle and while driving normally. Only happens under hard braking. Nobody I've talked to has ever heard of this one...
 
Ok I will try that. How can this be effecting the P/S? Just asking. Is it slipping or what? I can look up the torque settings but does anyone know off hand what that torque should be?
 
319 lbs of torque! Damn!
 
The gear that drives the oil pump and PS pump is a slip fit on the nose of the crank. It has no key and is retained only by the clamping force of the crank pulley. It is kind of a half assed setup for a high $$$ SUV. I use a 2 foot bar and hang my 160 pound ass off of it to get 320 foot pounds.
 
The gear that drives the oil pump and PS pump is a slip fit on the nose of the crank. It has no key and is retained only by the clamping force of the crank pulley. It is kind of a half assed setup for a high $$$ SUV. ...

Maybe, but at least it gives a warning that it's loose. I have seen way too many key setups driven loose, until the crank was ruined, because there was no way of telling it was loose. I would much rather have the steering become inconsistent, tighten the bolt, to having to replace the crank, harmonic balancer, etc.:hillbilly:
 
Maybe, but at least it gives a warning that it's loose. :hillbilly:


Some warning.

Most people probably won't think to check the crank pulley when their PS goes out and because they are freaking about their PS, they may not notice that they have no oil pressure either as their engine siezes on the way to the shop to have their PS fixed.

No doubt that bad things can happen when a crank bolt comes loose, but I'll take my chances with a Woodruff key set up any day.
 
Thanks for the info! I am a long time 40 guy so these "newfangled" motors are greek to me! lol. I'll try to torque it this weekend.
 
I have a 96 LX450 that is making noise like the power steering is going out. It also has a weird issue where it sometimes just dies out/cuts off. RPM gets low. There have been a few times when it just wont crank but if I just sit there for a few minutes it will usually come back to life. It is not predictable at all. Could it be the same issue you are mentioning here or would that kind of be an "all the time" problem and not sporadic. Like I said the power steering noise is daily but the low RPM and cutting off is periodic/sporadic. Also, Im a bit confused on what I should be using for Power Steering Fluid. I see people saying different things...
 
Last edited:
Back
Top Bottom