Lower intake manifold ON Head while installing?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

musthave

All maps, one app!
Supporting Vendor
SILVER Star
Joined
Sep 4, 2013
Threads
729
Messages
5,910
Location
Florida / Colorado
I am getting ready to install the cylinder head after having it back from the machine shop. I have the new harness in, and have it moved such that it is no longer running through the lower intake.

I'd prefer to install the lower intake on the cylinder head before I put the head on. I can't see why that wouldn't work. Anybody ever done that?
 
I am getting ready to install the cylinder head after having it back from the machine shop. I have the new harness in, and have it moved such that it is no longer running through the lower intake.

I'd prefer to install the lower intake on the cylinder head before I put the head on. I can't see why that wouldn't work. Anybody ever done that?
Yes, you can, but it may make it awkward in balance when installing to get it to set clean and easy onto your new head gasket. It would make it easier and cleaner if you are setting it onto studs.

If it were me, and I was using factory head bolts, I would leave them separate and bolt the manifolds on after the fact.

FWIW YMMV
 
cut the lower intake manifold between 4&5 install the head hook up the engine electrical harness the install the lower intake.i will see if i tok pictures of what i did,makes connecting the harness easier when you can see why you are doing.granted some of the lower intake manifold bolts are a pain to get to but it can be done.
 
New factory head bolts, and new studs for both intake and exhaust manifolds. I'm doing it alone so I'm going to use an engine hoist and just go really slow. Things go in cleaner with the new studs, fuel filter already mounted, etc.
 
yea i can see doing it that way if you still have all the stuff attached to the lower intake(filter and spaghetti mess).without all the spaghetti mess underneath the fuel filter is easy.
 
Reading the FSM around EM-53 it actually states to install the intake manifold, top and bottom. Along with sensors, etc. before installing the head.
 
Back
Top Bottom