Looking to borrow SC pulley removal tool

[Bhudzallmighty]

Hello! I read somewhere here that somebody made a tool and has been passed around. I’m looking to downsize to a 3” pulley. I can pay for the shipping! Thank you

 

[Fj80oregon]

SuperCharger belt wrench

This long handle zero offset box wrench is the perfect tool for removing/replacing the serpentine belt

landtankproducts.com

 

[LXDOC]

Pulleyboys.com sells them. You can use your hands. Gently tapping with a rubber mallet as you rotate the pulley will usually get it moving.

 

[Irish Reiver]

Hello! I read somewhere here that somebody made a tool and has been passed around. I’m looking to downsize to a 3” pulley. I can pay for the shipping! Thank you

Are you referring to the SC pulley attached to the crank? If so, this has a 32mm bolt head. I made my own "tool" to hold the crank in place while i undid the bolt. Some of the standard tools in circulation may not have a center hole wide enough for the 32mm head due to the standard bolt being a 30mm head.

 

[Bhudzallmighty]

Are you referring to the SC pulley attached to the crank? If so, this has a 32mm bolt head. I made my own "tool" to hold the crank in place while i undid the bolt. Some of the standard tools in circulation may not have a center hole wide enough for the 32mm head due to the standard bolt being a 30mm head.

Hi, I’m talking about the actual supercharger pulley (attached to the snout). I’m planning on upgrading to a 3” pulley.

Also, do I keep the supercharger belt on to remove the nut holding the pulley? I assume it would spin if the belt is off?