Looking for a unicorn

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 10, 2017
Threads
45
Messages
122
Location
Phoenix
I am getting to the final stages of my cruiser build. Does anyone have or know where I can locate a hand crank guide bracket that mounts to the front bumper?
8B15A64C-34F9-40D0-8F08-9C434149AE49.webp
 
Classic Cruisers may have one, I'd give them a call and see.
 
Mark A. had some. Few years back. Maybe Foxfab made them
 
Mark A. had some. Few years back. Maybe Foxfab made them


Bought a couple of them from FoxFab years ago. These were only used in the US for a few years. The rod to start the engine was dropped pretty early. My 9/64 FJ45LP-B had the clips to hold rod. Didn’t have the rod or guide on the bumper when I bought it in 1996. These clips were held on with revits. I've had early FJ40s that had screws in places to hold the clips for the rod but no clips. Sure they is a market for these but if you run a winch or have anything else in front between frame rails the starter won't work.
 
Back
Top Bottom