Locker switch placement

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 9, 2010
Threads
219
Messages
1,488
Location
Amelia (east of cincy) ohio
I am ditching the lock right in the front of my 80 and going with an elocker axle. I bought the low range harness kit and kind of expected the switch to fit one of the dash blanks... it doesnt. Has anyone done the swap and where did you put the switch? My next best place is the plastic area around the shifter
 
I am ditching the lock right in the front of my 80 and going with an elocker axle. I bought the low range harness kit and kind of expected the switch to fit one of the dash blanks... it doesnt. Has anyone done the swap and where did you put the switch? My next best place is the plastic area around the shifter

Just take a file and massage the openings. They dont fit perfectly out of the gate but its better than making new holes
 
If you have a single din radio you can buy a switch plate from paranoid fabrication that attaches to the radio. Replace that cubby below your single din.
 
20190331_104528.webp
 
If you have factory lockers already do a search on the forum about wiring your front locker to use the factory switch.
 
Back
Top Bottom