Locker Install without gear change

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 28, 2013
Threads
25
Messages
487
Location
Bavaria
If I were to swap ARBs in place of the open carriers and keep the stock ratio, am I correct that the only variable that would need to be set up with the ring and pinion would be backlash? No other part of the set up should change, correct?
 
Backlash and carrier bearing preload are the only items you'll need to worry about. However, now would be the time to consider changing the pinion seal since you're already 90% of the way there. That would require a new pinion nut and crush sleeve (or solid spacer) along with the seal, and you'd need to reset the pinion bearing preload as well.
 
Back
Top Bottom