Let's play a game!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Normal marks from the bearings banging around, insufficient preload.

This was most likely the issue. I didn't end up reusing the spindles and made sure to be extra careful to ensure the preload was set right (using the fish scale) and haven't had this happen again.

:beer:
 
This was most likely the issue. I didn't end up reusing the spindles and made sure to be extra careful to ensure the preload was set right (using the fish scale) and haven't had this happen again.

:beer:

Reading you did the preload with the fish scale, but you’re running 37’s per sig line.

Might be better off doing the “torque it to _____ ft/#’s, then back it off, then torque back to _____ ft/#’s “ -method.

I forget the values, but I ran into this myself just on my 315’s/34.5” tires.
I had the same minor markings on my spindles too.
 
Now that you mention it, I think I might have done a combination of the two. It's been a while now but I'm pretty sure I used the fish scale just to make sure my torque wrench was clicking at the right time. When I did my beadlocks my wrench was quite a bit off at the lower end the scale.

Oof, my memory is terrible but if I had to bet my life on it that would be what I did.

:beer:
 
Now that you mention it, I think I might have done a combination of the two.........

Oof, my memory is terrible......

:beer:

Buddy, any of us who recognize each others’ username are now a good 6-10yrs in, so we’re all suffering from “I know more than I remember” -disease.

That’s why I didn’t quote a hard TQ / ft-# number.
I know there is one, but I forget it.
:( :doh: :(
 
Back
Top Bottom