Leaking PS Pump....Options?????

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 8, 2006
Threads
100
Messages
1,303
Location
Ball Ground, GA
My PS pump is leaking at the main O'ring. A new one from the stealership is around $300:eek:!!! What are my options...if any???

Thanks for any help.
 
You can re-build the pump if you have the FSM, I think the 93+ gasket kit is around 40-50 bones or the individual o-rings are $3 or $4 if you know for sure which one is bad.

Or post up in the Wanted Section, surf Flea-Bay or check a few of the vendors on here that sell used parts. You will most likely find a smokin' deal, better than spendin' $300 on a new pump anyway:grinpimp:
 
add another $20 for the bearing since that's not included in the rebuild kit, but it was pretty easy and the book lists the specs that the vanes should be at. of course, i haven't put my rebuilt one in yet ;)
 
IIRC regular ATF is the recommended fluid and guys that have run it after changing out regular power steering fluid, seeps and slow leaks improve. YRMV.:meh:
 
IIRC regular ATF is the recommended fluid and guys that have run it after changing out regular power steering fluid, seeps and slow leaks improve. YRMV.:meh:

x2, I always forget that. If you have added PS fluid, douche it out and get some fresh ATF in there and it may help with the leak;)
 
I have already put Lucus in there because the leak was that bad!
 
The pump is relatively easy reseal job. All of them that I have done were heat affected, seal, o-rings hard and/or cracked, no fluid is going to fix that. The bearing is a common number, readily available, but they run in fluid, well lubricated, don't think I have ever replaced one.
 
Cruiser Parts has them used for $100...prolly go that route! Thanks!
 
Back
Top Bottom