Land Rover Help?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 28, 2003
Threads
155
Messages
784
Location
Ohio
Please don't flame me! Hopefully you guys can help me and then I'll delete my post, I just don't know where else to get help! :o

A friend has a '97 Land Rover Discovery that she left parked outside for 6 months. We put a new battery in it and tried to start it and there was a puff of white smoke along with the solenoid click, after trying to turn it over a couple more times the solenoid stopped clicking. I discovered the wire between the solenoid and starter had melted so I put a new starter in it but when trying to start it, nothing, no solenoid click. Should I start checking fusible links? This is a new battery so I know that's not the problem. If the fusible link was bad would the headlights still work? Thanks in advance!
 
It worked fine when it was parked, she left it sitting because the cv joints were going bad.
 
I have to ask; Did you make sure to hook the battery up the right way? Hooking it up backwards would fry some electrical components and give you the smoke...
 
try the starter relay...probably burnt it out...it doesnt take much on a disco to fry electronics.

relay should be in the engine bay...try replacing it with the blower motor relay...they should be the same
 
Last edited:
x2 on the relay.

(at the risk of you burning down yer Disco, don't do what I'm about to say)

I once had a starter rely going bad on my 4Runner but since everybody's always said, "they don't GO out, they're either working or broke no in between" I couldn't chase the problem down.

I could take the relay out, and I had this special type of test light w/ a switch on it. It looked like a made for TV (said it on the box) and I've never seen another like it...anyway, I could hook it to the batt, ground w/ the alligator ground clamp and if I touched the right spot where the rely touched, jump it off w/ the battery.


I guess I was just bypassing the relay.

I later bought a relay and that fixed the prob, after I beat a hole in the starter :whoops:

THX for having the best electrics Toyota ....:cheers:


(haha, rubbing it in for the Lucas crowd :grinpimp:)
 
Lucas=darkness

with any land rover you can save thousands of dollars with a $4 tube of dielectric grease...the first thing i would do is unplug things one by one and put some on each connection.

nobody does this preventive maintnace...bad contacts on a TLC gives you intermitent problems...bad contacts fry rover stuff!

things to stay away from are any type of chip...and ecu multi prongs.

Permatex Dielectric Grease
 
Please don't flame me! Hopefully you guys can help me and then I'll delete my post, I just don't know where else to get help! :o

There's actually a Mud section for non-Toyota tech. Scroll down the main Tech Section page a bit and you'll see it.

I rarely venture outside of 80 tech or the CSC forum. I'm kinda surprised I even know that.
 
my only advice is the classified section....as in advise you friend to sell it:flipoff2:

sorry couldn't resist....x2 on redoing batt. terminal connections
 
Please don't flame me! Hopefully you guys can help me and then I'll delete my post, I just don't know where else to get help! :o

A friend has a '97 Land Rover Discovery...


Wait a minute... this sounds like a total setup... are we being 'Punked'?
Aaaaaashton, you can come out now!







Seriously, good luck. Don't know jack about LR's but sounds to me like when the cable melted, its shorted out and blew a fuse. whether its a fusable link or not, I wouldn't know. Also, double check your battery voltage as you may have drained it depending on how good it was when you got it off the rack and how long and hard you tried starting the Disco.

WET
 
i would check discoweb.org --
similar forum to ih8mud but with a superiority complex

wait I thought the only web site that had a bigger superiority complex than mud was supraforums...... I am befuddled and must check said web site out :grinpimp:
 
Well the starter I bought had the connections for the solenoid reversed (there was only one connector on the original and 3 on the replacement). I just had the connection wrong, :oI guess I should have tried to switch it before I dug through the kick panel where the starter relay is. Anyway, thanks for everyones help, she is running! Since there is a non-toyota forum, hopefully the moderator can move this for me! Thanks again!!! :beer:
 
Back
Top Bottom