Knuckle service ?

[x factor]

Any idea of how much MOS2 grease it takes to do a mini. This will be my first birf job.

I have to get this done before the Jambo or I'll be riding bitch.

 

[Polak]

That all depends on how close you live to the auto parts store

I'd say you'd be safe with 3 of the smaller tubs, but I'd recommend going ahead and getting the big kahuna so you have it on hand.

 

[Gumby]

I usually get three tubes, although two tends to do the job. Most people way overpack 'em.

 

[4rnr]

IMost people way overpack 'em.

AMEN!!!!

BTW I use maybe half of one of the small tubs. But then again I end up tearing down my axle probably 6 times a year for various reasons.

 

[PhilC64]

BTW I use maybe half of one of the small tubs. But then again I end up tearing down my axle probably 6 times a year for various reasons.

Probably because you only use half a tub of grease.

2 tubs is what I've used and I've usually get the Lucas RTG (Red Tractor Grease)

 

[tonyota]

Remember, Bill. PYS till it's full. I can get by on 1/2 of the big Kahuna tub. It's cheaper to buy bulk.
Your talking a
2 to 3 hour job for your first time. You better have this done by the Jambo. If not we'll have to call it PBS tour (pack Bills sh!t)

 

[x factor]

you better have this done by the jambo. If not we'll have to call it pbs tour (pack bills sh!t)

aaah, it's too much pressure!

 

[x factor]

Your talking a 2 to 3 hour job for your first time.

Well, I got it done in 1 1/2 DAYS!!!

I also lost my "performance" clutch Friday on the way home. No more ceramic ZOOM clutches for me. Had to put what's left of the stock unit back in for now.

 

[PhilC64]

I thought I was bad. Heck I just got mine back running. I just need to fine tune the timing and carb then I'm set.

 

[tonyota]

My 4.88s have arrived & the rest of my auto swap is kinda, sorta,nearly close to being almost partly complete ......so I should be good to go in just 9 more days