Knuckle differences, if any.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 10, 2017
Threads
24
Messages
967
Location
Washington
I bought a 2nd 68 front end from a guy swapping his out for a 78 front end with disks. I bought it for the 3rd member.....mostly.

My personal 68 has birfield’s....the 68 front end I bought has balls and spoons.

My question is....are the knuckles, spindles and stub axle bushings the same? Is there any work needed to clearance the knuckles to use the birf’s.😎

Curious minds need to know.😎
 
Mark, at some point right in that area, Toyota added the second stop limiter tab to the knuckle housing. Before that, there was only one stop per side. Other than that, the housing, spindle and arms are the same.
 
Cool beans….second question, are all brifield axles 30 spline (spider gear end)? I think my existing stub ends are 10 (hub end). Does that sound correct?

Also, anyone looking for a descent set of pre 68 ball and spoon front axles and stubs? I live in WA, pay for shipping and my disassembly beer tab, they’re yours🍺🍺🍺.
PM me if interested.
 
Six on the hub.

I could use the balls if they’re not badly scored. I wheel my’64 more than most.😉
 
Back
Top Bottom