Kick down cable

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 6, 2014
Threads
21
Messages
461
Location
Spoakne Valley, WA
Website
forum.ih8mud.com
Hey so my kick down cable rubbed on my exhaust on the Cummins, cooked of the insulated wrap and started to melt into the plastic jacket. It is now hindering the function of the cable and not allowing it to retract all the way or to idle down the last bit without pulling up on the skinny pedal. And of coarse I am on a trip when this happens.

Think there is any immediate concerns or can I keep going till I get home?
 
If that housing collapses the cable won't work at all and you'll have tranny issues. Get it somewhere to replace than while it still goes forward.
 
What trans are you runnin? On the a343f it's just rail pressure I believe the 442 is as a well. As long as it's still going full open it will just make for stiff/hard shifts. The computer does the rest.

It sounds like it may be effecting your throttle not returning?

Sent from my SM-G900V
 
It is the a343f it is hard shifting a bit. I am wondering if my throttle is a different problem though unless the trans cable helps pull the throttle back as well. I prob need to replace both the pedal cable because the outer jacket is cracked off in some spots and the trans cable because the melted spot.
 
It shouldn't be helping the return. I'd lube it up to see if you can free it a little and drive with it. You have to drop the pan to replace. The newer trans have electronic rail pressure. I've thought about grabbing an a343f from a 100 series to see if they swap and get rid of the "kick down cable" that will only happen if I have issues first though. Hope I never get to that point.

Sent from my SM-G900V
 
Having it shift hard is better than having the cable stuck in a low-throttle low-pressure position and shift slowly.
 
Back
Top Bottom