Is it normal

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 4, 2011
Threads
22
Messages
269
Location
Texas
to have a hard left pull in 4low and all 3lockers locked?

I broke an pass axle and put In both side RCV 30-30-30's with full bearing knuckle rebuild.

I don't remember from before, but the rig was down for almost 6months and I am just now getting back out using it.

Thanks!
 
If the birfield joint was old and worn and I'm reading you right you were in 4 low locked ,turned, and gave it gas and broke it yes that's normal.

Fully turned with the axle locked you have to be very careful with the gas pedal. Don't think you'll have that issue with new chromoly birfs though
 
No. Unless you are on a hard surface with good traction, then there is no 'normal'.

When I removed a birf and drove the truck home, it pulled hard to one side when it was locked. In snow and mud.
 
Sorry. Yes I broke the birf with hard ft turn fully locked and boiling fuel so smooth power wasn't happening.

Now it is all back together and new axles and it has a hard left pull on flat ground packed dirt road. Just exercising the system and noticed it.
 
I miss read it. I thought you were asking if breaking a birfield with a hard left turn locked was normal. As far as the truck pulling left after your rebuild nope can't say that's normal..with it being apart for a while I'd guess the steering tie rod ends lost their position and you need to align it better if everything is back together as it should be
 
When I got my truck it had different size tires on the rear axle and when I tested the rear locker it pulled hard towards the smaller tire side. I'm guessing your tires are the same make and size but maybe tire pressure differences could make this noticeable, or perhaps extreme wear differences?
 
I have a completely new set of tires going on in the next few days. Hope that helps.

Alignment is also on my to do list.
Good ideas! Thanks!
 
Back
Top Bottom