Interesting Diff Breather Idea

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 9, 2006
Threads
110
Messages
2,158
Hey guys, I searched some but couldn't really come up with any answers. Mostly due to, I think, the fact that I'm not really sure what to call it. I was wondering if anyone had tried a setup like what is on the end of some snorkels. Swimming snorkels I should mention. Basically, they let you breathe in and out fine, but it won't let water down in there when you go under. I couldn't really tell how it was set up as it had a guard of sorts around it and it was my buddy's parents and I didn't want to tear their snorkel up. But basically I think it is like a reverse siphon or something...maybe. But it would get rid of the need for termination points way up in the engine bay and stuff. I don't know...it is probably to risky to try on valuable vehicles but I thought I would run it by everyone. Any thoughts? Anyone tried anything close? Just curious.
 
That's the way the truck comes stock. A valve on the end that won't allow water to pass. As they age they're prone to failure.

-Spike
 
Oh okay. Well, I just checked my front axle one because it was plugged which caused the pinion seal to leak when it relieved pressure out of there. I found the breather cap way up inside just below my steering box. It had just been gummed up over time. I have a '92 FJ80 by the way. Are they all up inside? My rear axle breather is up along the floor boards above the axle. Is that stock or did someone change it before?
 
Diff Breathers

They come stock with a flap inside the cap on the end. Most common problem with them is that they become blocked but even when they are working correctlty they have issues.
If you approach some water after driving for a while you have a nice hot diff ful of hot oil and air. Assoon as you hit the water the axle housing will cool down and all that hot air will contract and suck air into the diff. Unfortunately the flap is either blocked and shut or it will suck shut and then there will be a small vacumn inside your diff. Then it will suck water in through anywhere it can.

So the best solution is to extend the breathers up into the engine bay and fit a cheap inline fuel filter on the end of each line to allow the diff to breath.
 
Thats probably what I'll end up doing. I guess I didn't explain my idea well enough, but it had been to not have any lines, but a fitting right on the breather that didn't have moving parts but wouldn't let any water in. I guess it would be too hard to figure out though. I'll probably just do that.
 
Back
Top Bottom