interchanging heater control valves

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 16, 2003
Threads
53
Messages
196
Location
Washington DC
I have 2 heater control valves, one that mounts directly on (and is rusted out at the valve) and another that doesn't quite fit (but the valve cylinder is fine.... can the valve section be transplanted? it looks as if it is held on by 4 folding flaps, but hard to tell with so much gunk on it. wondering if anyone else has done it.
 
W/O any more info, your best bet is to open both up and try. Someone here might be able to help if you tell us what vehicles both came from.
 
one is from 1980 fj40, the other is from an 81 fj40 the cannisters are identical... and i just nutilated the bad one to get it out.... just trying not to mutilate the good one....
 
here is a pic of the unit... it is the cannister at the bottom i am trying to get off cleanly....

the 81 that i got was a different mode... trying to mount the cannister from the 81 on the body of the 80
 
Last edited:
I would just put a ball valve with a lever on and go under the hood to turn it on
 
Back
Top Bottom