Build INSTALLING A SUPERCHARGER… AT 239k MILES… IN 2025.

[TNFZJ]

M22 bolt. My kit came with the grade 8, but I wanted to make sure I had the correct length/pitch.
Sold in packs of 5. If anyone needs 4 big ol bolts, let me know. Haha

 

[TNFZJ]

.

 

[TNFZJ]

More small parts gathered.

 

[TNFZJ]

.

 

[TNFZJ]

2 odd sized hoses that HPS didn’t offer. I was able to source at my local auto parts store.

 

[TNFZJ]

This coolant pipe was hand fabricated for me by someone in the community.

 

[TNFZJ]

This is the vacuum hardline. Also fabricated by hand for me. A rubber hose could have been used in its place, but I am fortunate to have it.

 

[TNFZJ]

Living near the ocean, I wanted to ensure corrosion will be prevented as much as possible. McMaster-Carr has a good selection of 316 Stainless steel hardware not available local to me.

 

[TNFZJ]

.

 

[TNFZJ]

316 Stainless steel nyloc nuts can be hard to find.

 

[TNFZJ]

316 Stainless steel hose clamps.

 

[TNFZJ]

.

 

[TNFZJ]

I may run into interference issues with the clamps. I won’t know until installation day.

 

[TNFZJ]

3” diameter silicone hoses. The longest hose you see will be trimmed down to the correct length.

 

[TNFZJ]

3.5” to 3” reducer hose

 

[TNFZJ]

These clamps seem to be a bit wider than the standard clamps. I may have to rethink which clamps I use.

 

[ppc]

You may find the need to use a hump hose coming off the supercharger plenum for better alignment than a straight section.

Amazon product ASIN B004O9ERS4

 

[TNFZJ]

Initial test fit is a success.

 

[TNFZJ]

The 5/8ths Adel clamp fits perfectly over the coolant hose

 

[Vulkyn]

Is there a wiring diagram for the installation? I can't wrap my head around how the components all fit together