inner axle seal source?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 19, 2004
Threads
12
Messages
64
Does anybody know if any auto parts stores or the toyota dealer will sell just the inner axle seal without the whole kit? Where I might be able to get an axle seal anywhere near atlanta?

Local yota dealer wants $244 for the kit and I'm on the "laid off" budget.
 
The inner axle seal is not in the kit.


90310-35010.
 
The inner axle seal is not in the kit.


90310-35010.


Woot. 9 bucks and in stock!


I replaced everything about 2 years ago and I'm leaking again. I "should" just be able to dig in enough to get the axle out , swap the seal, and button it right back up... Am I correct or am I gonna need anything else... Maybe the wheel seal?
 
Toyota's published list price is $8.49 a copy on the seals.

I would also have 43435-60020, 43436-60011, 90215-42025, 43422-60060, all x2.
 
Consider Marlin's heavy duty inner axle seal.

I ordered everything from Mr. Cdan to do the front end job, also ordered Marlin's inner axle seal. It fits the description of "heavy duty" perfectly.

HD Inner Axle Seal, FJ80 | Marlin Crawler, Inc.
 
Whew, well that wasn't as bad as it was last time... Everything is easier the second time I guess.

So anyway... I jack her up and give some tugs on the wheel and sure enough, lots of slop in every direction. Damn, now I guess I'm doing the bearings (which I don't have) too. Oh well, lets yank her apart and clean it up good and I'll scare up some parts on monday. I get to the 4 bolts on the steering arm and what the hell, they are all loose as can be. Spun all 4 off with my fingers and all but 1 of the cone washers dropped off too. Well I'll be damned, that would explain all the play in the wheel wouldn't it? :) What the hell lets put the nuts back on and see if that cleans up the slop. Eureka! worked like a charm.

I buttoned her up good, dropped new rubber seals in and managed not to bugger up the paper ones. Hopefully this will hold for a while until I can scare up a J.O.B.

Thanks Mudders for pointing me towards the right parts and having the FAQ with pics. It was a huge help!
 
Be careful! The problem you have is usually with the studs, not the nuts. The studs are most likely loose in the knuckle housing so the nuts will come loose again, with potentially disastrous results (especially if you are driving anywhere). The fix involves removing the knuckle housing, taking out the old studs, replacing them with new studs torqued down and/or loctited, and reassembling.
 
Just recheck the torque relatively often (500mi?) for a while. If they turn before the wrench clicks to the torque number, they are loosening and will need attention, if they stay tight you're good to go. I check them often, part of my trail run check list.
 
Back
Top Bottom