Ignitor box

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 6, 2005
Threads
55
Messages
412
Location
EAST COAST
I have worked on a few engines in my time, but I have never heard of an ignitor box. When I bought my fj40 it was already disconnected, and when I rewired I left it out. What is this thing supposed to do? Produce more or reduce the spark before the coil? Anyone else not using this?
BTW, i DID THE SEARCH AND FAQ THINGS,, i wasn't able to find much info on this.
 
Ignitors are electronic switching devices that do the job of the points on a mechanical system.

First generation ignitors (75-78) still use points to switch, but the ignitor amplifies the current so that only a tiny current crosses the points. This prevents the points from arcing and the contacts from pitting. Second generation ignitors (79-up) use a magnetic pulse to trigger the coil instead of points.
 
okay, PO installed an electronic ignition, I guess thats why its not installed.
Normally with a stock engine and all, what would happen if the ignitor wasn't tied in? would it still run okay? Just curiouse.
 
Depending on the year it might or might not run :) If it's the earlier type like mine (1977) it has a semi electronic module and like Pin Head said, it just amplifies the spark so the points don't wear down. This type will run. If fully electronic, you're dead in the water.. no way to run. Both types have their advantages and this is one advantage for the points type.
 
Haynes manual says the igniter "improves spark during slow running conditions. " Also somehow increases the longevity of the points. It REPLACES the condenser; if igniter then no condenser either in line or inside the distributor. The igniter can go bad on you. Haynes even has a diagram showing how to bypass the igniter on the trail if it goes bad: just disconnect the igniter and wire in a condenser (you must carry one) in its place; will get you by in a pinch to allow the rig to run. I personally think that simpler systems are better, especially on the trail; less variables to go wrong. Yesterday I took off my (77) coil, igniter, and distributor. I replaced everything with NEW non USA stuff from Specter, to include an old style (no igniter) coil. The non USA dizzy has a condenser inside it. Two wire hook up; all others plugged. Ignition hot wire to POS on coil and NEG on coil to distributor. Also, the old style coils (up to like 69 i think) had internal ballast resistor; no need for an external one. I think the ballast resistor on my 77 coil was integrated into the igniter; anyway you can't run that coil long term without adding a ballast resistor I think. Not sure if you need a ballast resistor if you run electronic distributor; but you prolly do I would check. As soon as I got the rig running I had to go to work so no report on how she runs at speed. I had some rough running issues with my (rebuilt) moter prolly related to spark and timing; I'm hoping these mods smooth them out and simplify. Later.
 
Back
Top Bottom