Igniter question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 13, 2006
Threads
45
Messages
86
Location
Sabinal, TX
Website
www.brushyhill.com
Hi there y'all! I just bought my first Land Cruiser- a 02/1975 6-cylinder. It has been a 25 year dream of mine to own one and a buddy of mine sold me one for my birthday last week- for $500! It runs pretty well but has two problems: 1. It needs new front brake/wheel cylinders because they won't retract all the way despite all the penetrating lubricant we've tried to work through them. and 2. It needs a new Igniter- at least I think it does.

My buddy took out the igniter, which broke, back in 1998 and put in a bigger coil and ran it like that because the only replacement he could find at the time was $300! Well, it just isn't a big enough coil and the result is some gas-fouling of the plugs. Another friend of mine wants to help me put on a high-output coil to increase the amount of spark enough to prevent the fouling. But before I do that, I wanted to see if y'all had any suggestions on where (websites?) I might be able to find a new igniter for a more reasonable price- possibly with a coil? I have the original coil, but who knows if it was in really good shape so if I replace the igniter, I figure I might as well replace the coil too.

Also, do y'all have any better suggestions? I mean, would YOU recommend going back to the stock setup with an igniter or something else? If so, what would you recommend? This is a ranch/hunting vehicle in South Texas so I'm not going to be doing any rock climbing with it nor am I going to be doing a lot of highway driving with it. I'm looking to make my FJ40 as quiet as I can but as good at going through deep mud, shallow rivers and up soft dirt embankments- we don't have a lot of mountains on the ranch but some of the thick brush covered hillsides are pretty steep. Just so you know what I'm trying to do with it, in case it makes a difference n your recommendations.:popcorn:

I'm glad to have found y'all and I sure appreciate any advice I can get!

Nick Anderson
Austin, TX

P.S. Please feel free to email me if you want to!
 
Welcome.


A good upgrade would be to install an electronic distributor and ignitor assembly from a 1980 and later 2F engine. You should be able to find the pieces needed for this swap by posting up in the WANTED section....these things are also for sale occasionally, so I would look there as well...



On the brakes....I would look at installing discs up front.

There are many threads out here that detail this swap.

Hit the FAQ or the Technical Links
and read away!

Good luck!


-Steve
 
The ignitor went bad in my FJ40.
Rather than replace with new, I simply bypassed it.

I have a non-usa Distributor, which has a condensor in it.
I also have a ballast resistor in the setup.
You can run it with one or the other.

One option you can do is to take the wire from the distributor and connect that to the coil negative (ground). This bypasses the ignitor.

run it that way.

Or, you can put in a pertronix setup. This replaces the points and the ignitor.

I run a points style distributor, and have the ballast resistor bypassed (I have a condensor in my dist). Starts, runs great.
 
I have a new Pertronix distributor and a new coil to sell. PM me if you are interested.
 
Back
Top Bottom