IFS axle angles

[Hypoid]

Hey guys-

I've had some poor alignment and would like to return the lower control arms/CVs to stock angles as a starting point.

Does anyone have IFS and haven't screwed around with the torsion bar adjustments? If you have, could you take an angle finder and measure the CV axle shaft for me? I'd sure appreciate it.

Thanks

 

[NorCalBorn]

Here's what I go off of: http://www.ncttora.com/fsm/1990-199...toypdf/95rmsour/1995/954runne/sa/wheelali.pdf

You measure from the ground to the a-arm bolt and then to the spindle. Tire size needs to be factored in, realize those specs are likely relative to a 31" tire. Then you just back down or turn up on the torsion bars to get the final numbers.

 

[Devil's Slide Doug]

13.5 to 14" from top lip of 15" rim to the edge of the fender well .
Torsion Bar Adjustment - Trucks 4x4 @ Off-Road.com

 

[Hypoid]

Thanks

I suppose the fender measurement applies. I was thinking funny, that it wouldn't apply with BJS, but I wasn't thinking straight. Thanks for the reminder to check the FSM, I don't know how sometimes I don't think to.