I'd like to kill whoever designed....

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 29, 2008
Threads
26
Messages
195
Location
CA
...the antenna in these trucks. I'd rather replace my tranny again. Between broken metal inside the antenna, stripped bolts, and absolutely no room to work on the antenna once you pull it out, this is one of the stupidest things I've had to do on this truck.

Something that should be so easy....:mad::mad::mad::mad::mad::mad::mad::mad::mad::mad::mad::mad::mad::mad::mad::mad::mad::mad::mad:

:crybaby:

And I'd like to say that it doesn't help being 90000000000000000000000000000000000000000000000000000000000000000 degrees outside here today!!
 
What's so hard about it? Just remove the fender!

DSCF2013.jpg










I feel your pain. I removed mine too :D
 
It was designed by the same engineer who did the windows!
 
Toyteg08,
I am laughing so hard right now. It so funny!!! I had a similar frustrating experience. Trying to change a tire on a humvee and it was so hot the jack would sink into the asphalt and the jack was made for the vehicle before they added all the armor. They jack exploded and it was so friken hot in our armor. And we even got shot at while doing it. I feel your pain and am laughing because I know frustration so well.
 
Thanks for your service. I hope some day you guys will not have to get shot at and the rules of engagement let you decimate a city block in response to a single gunshot versus what's in force now. Would cut down on people shooting at you while you change a tire, I suspect...

DougM
 
^ LMAO, sorry but it cracked me up when i read the forecast, our highs (100's) are Pheonix's low's. Nice n' toasty.
 
pansies :flipoff2: We have been having consecutive 110+ degree days this week. Low, is 91 over night. If I was in CA i'd be wearing a sweatshirt and sippin hot cocoa!! Ha! Ha! (Heat sucks, im swapping out my fan clutch fluid today) Thanks Kevin(Tools R Us)
115.webp
 
Hey Idaho Doug,
actually the last time I got shot at was sept 8th, they dont do it that much in Iraq these days. ( all the brave ones are dead) I still remember an abrams tank using a full-can round against one terrorist.(giant shotgun shell) I am so glad to be back in the states and I just want to see my Cruiser again. I think it might happen in 3 weeks
 
Low, is 91 over nightim swapping out my fan clutch fluid today) Thanks Kevin(Tools R Us)

Yeah I havn't seen morning (4:45am) lows under 93ºF recently, crap it's still gotta be 110ºF out there right now, bloody hell doesn't matter how long you live here it just doesn't get any easier. Apparently we here get a little more really pleasant humidity to keep the temps a little more stable :O

AZrider, LMK how long that fluid swap takes. I gotta do it on our DD and I'll only have like 1 night's downtime.

Cheers,
hot.GIF
 
Pskhaat- mines a DD too, so I have one day to do it too. Just a few minutes to pull it out and put it back in. 4 12mm nuts to seperate it from the water pump, then take out the 2 top bolts from the shroud. You can either squeeze it out the back or the front, Kevin says front, but I got mine out from the back. Take the fan off, then 4 T25 screws and it pulls apart. Then I propped it up out in the blazing sun to drain and a few hours later I was at Kevin's shop to have him put the fluid in. Then just put back in. I would say 15 minutes to pull and dis-assemble, 25 minutes to clean it up and fill with fluid, and another 15 minutes to put it back in. The time consuming part is the draining, some use an oven, I used the fire ball in the sky.
DSC_0001.webp
photo1.webp
 
Sorry to hear that something so simple turned out so bad for you. Having done two, one to replace the cable and the mast in the other I can say it is much much easier to do than you make it out to be. Striped bolts can foul any job and turn a simple project into an all day event. :frown:

Yeah, stripped bolts suck. So do rounded out screws, and a piece of the old metal antenna stuck down inside the base of the mast. The fiberglass cord isn't even broken - my garage door just didn't go up all the way one day for some reason, caught the antenna, and snapped it clean when I backed out.:mad::doh:

Oh, don't forget a nice, big, fresh scratch on my fender now. Gotta love that. That's just awesome.

It SHOULD be simple. Not for me.

Toyteg08,
I am laughing so hard right now. It so funny!!! I had a similar frustrating experience. Trying to change a tire on a humvee and it was so hot the jack would sink into the asphalt and the jack was made for the vehicle before they added all the armor. They jack exploded and it was so friken hot in our armor. And we even got shot at while doing it. I feel your pain and am laughing because I know frustration so well.

Yeah, I guess getting shot at while wrenching would be the only way it could get any better. That sucks dude.
 
Toyteg08,
I am laughing so hard right now. It so funny!!! I had a similar frustrating experience. Trying to change a tire on a humvee and it was so hot the jack would sink into the asphalt and the jack was made for the vehicle before they added all the armor. They jack exploded and it was so friken hot in our armor. And we even got shot at while doing it. I feel your pain and am laughing because I know frustration so well.

Yeah, that is ALMOST the same as trying to work on the antennae... LOL.
 
Global warming is killing me :)

Statement as of 1:19 am EDT on July 17, 2009

... Record low high temperature tied at the Marquette National
Weather Service office yesterday...

The high temperature yesterday July 16th was 63 degrees. This tied
the previous lowest high temperature for that date of 63 degrees
which was set in 1975 and again in 2004.

Weather records for the Marquette National Weather Service office
located in Negaunee township date back to 1961.
 
Global warming is killing me :)

Statement as of 1:19 am EDT on July 17, 2009

... Record low high temperature tied at the Marquette National
Weather Service office yesterday...

The high temperature yesterday July 16th was 63 degrees. This tied
the previous lowest high temperature for that date of 63 degrees
which was set in 1975 and again in 2004.

Weather records for the Marquette National Weather Service office
located in Negaunee township date back to 1961.

:confused:
 
Back
Top Bottom