Hub no disengage!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 20, 2005
Threads
41
Messages
156
Location
Monticello, UT
Good morning! Last night I was finishing up a knuckle rebuild on my 1978 40 and my pass side Selecto Hub will not disengage. I took it apart to clean and regrease it and when I got it back on the cruiser it will not do what it is supposed to. It will engage but it will not turn back to disengage. Has anyone had a problem like this or any directions that I should look? Everything is assembled correctly and the other side works fine? Weird? I know that I need to find a pair of Asians and I will do so but until then thanks!
 
Muspos said:
my pass side Selecto Hub will not disengage. I took it apart to clean and regrease it and when I got it back on the cruiser it will not do what it is supposed to. It will engage but it will not turn back to disengage. Has anyone had a problem like this or any directions that I should look? Everything is assembled correctly and the other side works fine

Assuming you put eveything back together properly, did you by chance over fill it with grease? I had this problem with both Aisin's and Warn's. Too much grease did not allow the collar to slide. Just an idea.
 
Last edited:
not sure steve, but i think the correct terminology is "grenado" :D
DSC01023.webp
 
Muspos said:
Good morning! Last night I was finishing up a knuckle rebuild on my 1978 40 and my pass side Selecto Hub will not disengage. I took it apart to clean and regrease it and when I got it back on the cruiser it will not do what it is supposed to. It will engage but it will not turn back to disengage. Has anyone had a problem like this or any directions that I should look? Everything is assembled correctly and the other side works fine? Weird? I know that I need to find a pair of Asians and I will do so but until then thanks!
Does the hub operated correctly on the bench?
If not make sure the return spring is attached correctly inside the hub.
If so I would take the collar out and check to see if it binds on the axel stub. If it binds the collar is worn.

Meanwhile start searching the interweb for junk yards that carry import parts. I found a set of Aisin hubs for around $80 from a yard in Washington.
 
rusty_tlc said:
Meanwhile start searching the interweb for junk yards that carry import parts. I found a set of Aisin hubs for around $80 from a yard in Washington.



Aisin LOCKOUTS for a drum brake axle....now that would be a novelty item. ;)


:beer:
 
nuclearlemon said:
not sure steve, but i think the correct terminology is "grenado" :D



Disastro is another...


Ejectro- Saw one fail and the cap came shooting off at me. :)


They are smelter fodder at best.


:beer:
 
rusty_tlc said:
I've always been irritated that my 40 was made in March 1975.

<Don Adams>
Missed it by that much!

That's a blessing Kalifornia, mine is 4/75 and it means no more smog check...I'd rather deal with a front disk conversion than smog check until end of time. I couldn't dare imagine my '75 on a smog treadmil :eek:
 
mustardfj40 said:
That's a blessing Kalifornia, mine is 4/75 and it means no more smog check...I'd rather deal with a front disk conversion than smog check until end of time. I couldn't dare imagine my '75 on a smog treadmil :eek:
Mine barely passed with the smog pump off and air rail plugged last time. NV smog is pretty lax. ;)
 
Back
Top Bottom