How how do I remove the interior door panel?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 10, 2015
Threads
55
Messages
139
Location
Tulsa OK
I have a 97 LX 450. I've been trying to pinpoint and fix all rattes in the car. There is one left and I think it's inside the passenger side front door or rear door. I don't want to break any plastic bits...so what's the proper way to remove the interior door panel's?

Also are other people as OCD about fixing rattles as I am? I like the ride to quite as can be when the radio is off.

Thanks!
 
Front doors you have to remove the latch lever trim piece and the screw in bottom front of pull bar. After thats its carefully popping lose the panels plugs starting at bottom. Once all 3 sides are lose it should lift up. You shouldnt have to mess with triangle trim by mirror but if so it pries right out. Secured with press fit pegs like the turn signals up front.
 
Search is your friend. There are several good threads on MUD with lots of pictures and step by step instructions.

It's not a hard job at all, but if you've never done it, you need the instructions...
 
Go slow, don't force anything, pick up the two pronged fork looking upholstery tool from any autoparts store to help pry the plastic rivets loose. Be sure to get the top most rivets loose. With the window all the way down, pull out a bit at the bottom of the panel, then push up to free the top of the panel from where it curves around the upper aspect of the door. The molding at the top of the panel is pinched in place near the window opening in the door and the panel needs to come up and out before it comes off. If you just bend the door panel out at the bottom and yank on it you can break the (hidden) plastic section that forms the rounded edge at the top of the panel.
 
Rattles bother me too, but I've not been able to track down all of mine yet. Post up what it is if you figure it out!
 
Back
Top Bottom