Hovercraft mod - COMPLETE!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 25, 2005
Threads
146
Messages
1,857
Location
Prescott Valley, AZ
HOoray!



IMG_0753.jpg




But on a serious note...it wasn't nearly as hard as I thought it would be to get my 3rds out...

IMG_0754.jpg


The birf grease was nice and greasy thick - no soup mix.

Barely any shavings on the drainplug magnets...

Tomorrow I drop off the 3rds at ZUK's shop, spend the day shopping for more crap I don't need, and when I'm done I'll have some purdy new 5.29s and ARB lockers to toss back in the truck.

Weeeeeeeeeeeeee
 
On another note....my 8" springs are here for more ridiculousness.

With the 6" Slee Springs and the L shocks...how much down travel is there in the L shocks?

Will I be needing extended length shocks for the bigger springs?
 
On another note....my 8" springs are here for more ridiculousness.

With the 6" Slee Springs and the L shocks...how much down travel is there in the L shocks?

Will I be needing extended length shocks for the bigger springs?


No, you can run L shocks on any 80 lift. :flipoff2:
 
On another note....my 8" springs are here for more ridiculousness.

With the 6" Slee Springs and the L shocks...how much down travel is there in the L shocks?

Will I be needing extended length shocks for the bigger springs?

Cod, if you want to use the full ability of those springs I would upgrade to a 14" shock. You will need longer custom brake lines if you do so. Who makes the springs?
 
Apparently they are a one-off Slee 8" coil...
 
Slee has access to some longer 700mm [27.5" with 12' stroke]front shocks, and 735mm [29" with 12' stroke] rears to match the spring colors, and valving to suit. [unlike OME....]

We have had them made to suit the 6" plus coils, and our 3-4" slinky coils.

They require an adaptor on the rear, that bolts on, to move from pin to eye, to reduce side loading on the shock shaft and seal, but bolt on otherwise with 40mm bump spacers.
rubyrearshockadaptors.jpg

You can also turn the adaptor around with bigger bump spacers increasing the shock droop by 50mm over the 'standard" position up inside the hole in the chassis.

I am running the shocks and rear adaptors [the right way] on project ROOBY.
80extractors.jpg


If they are a true 8" coil, you will need to make a steering arm with high mis heim joints, as the standard tie rods wont like the angle.
 
Darren, what do you mean you are running them the "right" way? Looks like your shocks are pin also?? What springs are those?
 
I gotta say 8" is more than I would want to tangle with.............

good for you for having the guts, I just hope it doesn't open a huge can of worms in other area's.
 
Darren, what do you mean you are running them the "right" way? Looks like your shocks are pin also?? What springs are those?

I have the rear adaptors facing up in through the hole in the chassis, like in the pic, with the shock out the bottom.

You can turn them around, as I stated, making the shock eye 50mm lower than the original position.

Do the springs in mine look anything like the hovercraft ones at the top post, in the front ;)
 
Back
Top Bottom