Hood Question???????????

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

If it is in decent condition and you are planning on getting the correct one, I would be interested in buying it?

Looking for a decent seemed hood.

Thanks, Matt
 
the prop rod comes out from the middle of the hood too, doesn't it?

anything after 3/72 should be good....mine is the one piece style and that's when my was produced


malphrus
 
early model hood is split hood, two halves spot welded together...by 74, they went to one piece pressed hood with a wide pressed raised rib down the center . you can also tell by the corners at the front bib. the split hood is a sharp angle to the bib, the one piece curves down to the bib.
 
If your thinking of selling it to me, I don't need the prop rod. It is still on the hood I have. The hood I have is bent up and full of bondo. I want to start with a nicer hood for the resto I'm about to start.

Thanks, Matt
 
I've seen hood years broke down by these years. I am familiar with the seamed and non seamed hoods. Where does the 72 - 74 hood fit in there? Seamed or non seamed, and then what's the difference from the one that it is similiar too?


58-71
72-74
75-83

Thanks, Matt
 
i know that my 3/72 hood is one piece and that's abt it, ha ha...
not sure of the changes that occured 74-75...

malphrus
 
Toyo FJ40 said:
The 72 to 75 hood has the windshield bumpers and hook mount holes in different spots than the 78. You have to redrill the holes on a 72 hood for the windshield to be able to lay down.

So all seamed hoods are the same, correct?
 
buckroseau said:
So all seamed hoods are the same, correct?

SOR lists the 58-9/71 hoods, the 10/71-12/74 hoods, and the 75 and on hoods separately. I also know the hood ornament spear, which went with the split hoods, was discontinued after 74.

But what exactly differentiates the E-9/71 and the later split hoods, I don't know.
 
by "seamed", do you mean split? if so, no, not all seamed hoods are the same...the holes for the w/s attachements are different...some had no holes, some were drilled for long flat rubber piece and some were drilled for stepped rubber piece.
 
The way to tell the 72-74 one-piece hoods apart from the 75 and newer without measuring the rest bumper spacing is that the 72-74s will still have the retainers for the windshield hooks, while the 75 and newer won't have them because the hooks rest on the windshield rest bumpers.

;)
 
My 10/74 is the one piece, so from 71 to 74 they must have been all one pieces. The way to tell a 75 on up from a 74 and earlier are the windshield hood bumpers. The ones on mine are huge rubber block thingies, but the ones on 75 on up are little rubber pads on metal mounts, not a mountain of rubber bolted to the hood. The 75 on up are more subtle, whereas the 74 on down are big and clunky.
 
Back
Top Bottom