Hi + Drivetrain question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 28, 2006
Threads
3
Messages
14
Location
Little Rock, AR
Hi everyone, I was finally able to find a 91! I've had a few 4runners in the past, but the LC is much nicer.

I have a question about what could be happening in the drive train. I know it's hard to diag over the internet, but maybe someone has some ideas. I get a muted clunk when I let off the gas. The axle/u-joints are good, but when I wiggle the front one, there's a little bit of noise coming from the transfer case.

If I drive in high and lock the diff, the noise isn't there on accel/decel, so I'm thinking something in the transfer case might not be right.

Any ideas?

Thanks all!

edit: here's a pic:

land_cruiser.jpg
 
Search on the regreasing the driveshaft slip yoke. When these get dry they make some noise and "clunk."

Do NOT just use the grease "zerk" on the shaft, as you can overfill the shaft and cause damage. You need to R&R the shaft and grease it by hand out of the truck.

This has been beaten to death, you can probably find something in the FAQ's or through a search.


Also keep in mind you just bought a 15 yr old truck. It is definatly not going to drive like anything 10 years newer. While the slip yokes may be a culprit, I bet it is just the sum of the slop that has developed over the years.
 
Search on the regreasing the driveshaft slip yoke. When these get dry they make some noise and "clunk."

Do NOT just use the grease "zerk" on the shaft, as you can overfill the shaft and cause damage. You need to R&R the shaft and grease it by hand out of the truck.

This has been beaten to death, you can probably find something in the FAQ's or through a search.


Also keep in mind you just bought a 15 yr old truck. It is definatly not going to drive like anything 10 years newer. While the slip yokes may be a culprit, I bet it is just the sum of the slop that has developed over the years.

x2

My 94 has the clunk when I accel from a stop, on mine its the front driveshaft slip yoke.

Try pulling your front driveshaft and drive with the center diff locked, if the clunk is gone you can almost be 100% sure its the front driveshaft slip yoke.

Welcome :flipoff2: <----- standard IH8MUD greeting
 
Thanks for the tips everyone (and the warm welcome ;) )

Easy enough to do this weekend. There's a lot of topics here, it's hard to get good search results unless you know what exact words to search for. Thanks again!
 
I was going to do this tomorrow, but how does this work? Maybe it's a silly question.

Right now, when getting on the gas or letting up:
clunk with center diff open.
no clunk with it locked.

If I take a drive shaft off and drive locked, there's going to be no noise, since I'm locked.
 
Back
Top Bottom