Help with stuck distributor.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 3, 2006
Threads
47
Messages
217
Location
Southwest, MO
Ok, I set out today to time my 40, do the lean drop and all the good stuff to try to get her running right when hot. I got stuck at the get go. Timing was of by 7 degrees according to mr. light. I loosened the clamp, and the the dizzy would not budge. Tried some pb and tapping, nothing.

Have any of you had this happen, and what did you do, short of dropping the pan, to get it out. I really really don't want to drop the pan I just got it back up 2 days ago.

thanks
 
I think you should have the same set up as mine, my motor is 1/79. there are two 10mm's, one horizontal and one thats a pain the ace thats verticle (should have a notch in it for a flat head (not like thats going to help you.)) If you loosen the one in the block with the horizontal bolt head, nothings going to happen. you have to loosen the verticle bolt thats underneath the dizzy to get it to rotate. Its about impossible to get a box end or ratchet up in there, but thats the one you need loosen.

hth, mike :cool:
 
I did loosen the right one, the one on the clamp. Mines not too hard to get too at all, through the pass. fender well. I tried to loosen both and wiggle the clamp but didn't help. It has been soaking over night in pb so I hope that helps. What do you guys think about getting vice grips or channel locks on it. Will I break anything if I grab on the shaft?
 
Back
Top Bottom