Help with Backfiring

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 18, 2005
Threads
14
Messages
58
Location
Orlando, Fl
So here it is...The carb. was rebuilt twice and is now mounted inside. Sandrider and I have tightened every exhaust and intake manifold bolt. All the seals inside the carb have been replaced and there is no leaking to be found in carb and for that matter any other part of the engine. The question is...why is it still backfiring? Is it because the carb has not been adjusted correctly or do you think there is another possible problem.. Anyone have ideas or is there something we've haven't done/checked yet that could make a difference. Were beginning to get fed-up with this...so help would be greatly appreciated!!! ::sigh::
 
when does it backfire?
Could be an intake or exhaus manifold leak, but you say there arent any leakes. Check all the hoses around the manifolds for cracks and leaks with carb spray. If it revs up when you spray on the intake- theres a leak. Exhaust leak can cause it to backfire on deceleration.
Fouled plugs? Bad spark plug wires. Retarded timing will cause it will backfire. Burned valves or valves in need of adjustment. Lots of variables...

-Dustin
 
Need some more detail here about when it is backfiring. As stated many variables may be contributing to this. If you are completely 110% sure it is not your carb it probably isn't. I put a differant alt on my cruiser and it would backfire. Found out alt was junk and causing timing problems (do not think I tightened it far enough, fan belt too loose) Took the alt off got a new one and made sure I had it good and tight. No more backfiring or any problems. I knew it was my alt though because it was not backfiring before I took the old one off and that was the only thing I changed. good luck to you.

:cheers:
 
Mine does the same thing, more when first started but I can almost always expect a backfire the first time I shift it into 3rd gear. Not sure why and I just live with it but I wouldn't mind if it never happend again. It's almost always well giving it the gas. Also smells like it's running pretty rich. Has a holly carb on it, how do I adjust the two screws on there correctly?

Adam
 
Nick the Carpenter said:
dissy problem check point gap and retime.

Agreed. Your dizzy might be 180 degrees out and do that.
 
The carburetor is the victim, not the culprit. Check compression with valves properly adjusted, and check timing.
 
Back
Top Bottom