Help, what is this??

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 11, 2007
Threads
13
Messages
35
First a little history. 1992, 170k, all stock except the previous owner straight piped the cats. It actually runs and idles very smooth. I have replaced, plugs, wires, cap, rotor, air/fuel filters, and O2 sensors. I get about 7-8 mpg and feel like I have very little power. I can't get over 70mph on a flat highway. I tried today to advance the timing to give it a little more pep. Turns out the distributor was already turned counterclockwise as far as possible in the slot. So I get to digging and find what is pictured below. Someone has put a jumper wire down by the drivers left foot area. Obviously with the reckless way it was done this is not of toyota's doing. So, I decide to disconnect the thing while the motor is running. It runs for a few seconds and the the rpms drop until it dies. Like the fuel pump just quit working. So, can anyone tell me what this wire is doing. Maybe someone with a wiring diagram can tell me what these wires go to. The first picture is just an overall so you can see where I am talking about. The second is the connector up closer to the firewall, the big yellow "jumper" is spliced into the red w/ green stripe. The third picture is the square connector that is tucked into the side/fender area. Here the "jumper is spliced into the blue w/black stripe. I am thinking maybe someone has bypassed a sensor or something causing the poor mileage and lack of power. Any help is greatly appreciated....
IMG_0732.webp
IMG_0731.webp
IMG_0730.webp
 
Ugh. What a mess. I spent some time in the EWD just now. The solid blue wire should be +12 to window motor or door locks. I can't see from the picture and I don't remember where the harness that runs through the opening goes so that's a guess. The red/green is circuit opening relay/fuel pump which would explain why it died.

It looks like the circuit opening relay has been bypassed. Have a look at the relay block in that kick panel. Make sure the relays are all there.
Relay Block.webp
 
Thanks jonheld, all the relay still look to be in place. The blue wire it is spliced into is actually blue w/black stripe. Can you tell me what that wire is? I think you are right about the fuel pump, that is exactly what it acts like. Also, I advanced the timing as far as the slot would let me, the farther I went the better the thing ran, just ran out of adjustment. I know its not the proper way, but as of yet I cant even find the timing hole, there are just too many wires in the way. I thought I would advance it until it pinged, but I just cant get that far?
 
Sounds like the previous owner was a real knucklehead. Your distributer could be 1 tooth off, but you won't know without a timing light.

Adjusting the timing should be the LAST thing on your list. I would spend some quality time getting this truck back to factory specs. You may have fuel delivery issues and who knows what else. The fact that this jumper wire allows the truck to run tells me that it wasn't running at all at one point and this is all someone could come up with to make it work.

The fuel pump relay (circuit opening relay) is fired from the switch in the AFM. If your AFM was molested then you're not getting proper signals to the ECU. You can adjust timing from now until the cows come home and she'll still run like garbage.

Take the time and FIX the problems first or this motor will never be right. Get yourself a factory service manual (FSM) and an electronic wiring diagram (EWD) either from Toyota Publications or downloaded, or from me, and have at it.
 
Back
Top Bottom