help removing parking brake cable

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 31, 2003
Threads
38
Messages
419
Location
E. Washington
I'm tearing down my tub in preperation for a new aluminum tub waiting in the wings. Things have gone pretty well so far, but I'm having a hard time getting the parking brake cable through the silver housing in my '79 40. It looks like I'm supposed to collapse several steel "wings" so that the diameter is small enough to pass through the hole. I'm sure somebody has done this before. Any suggestions? Those wings don't want to cooperate. Is there a work around?

Thanks

JJ
 
If the parking brake cable is disconnected from the drum under the truck, you are then able to remove the bucket and lever assembly from the floor, and work on the cable and bucket on the bench, and are able to rotate the cable in the mounting bucket and get those little locking tabs bent back down and the cable removed from the mounting bucket.


If the cable is still attached at the transfer case and you are not going to remove it, then your going to need to get a 90* o-ring pick or similar tool so that you can attempt to bend the locking tabs out of the way and get the cable out of the mounting bucket. This is a pain, but can be done.


I prefer wrestling with this set up on a workbench instead of in the truck when I can.


Good luck!


-Steve
 
Thanks fellas! I'm on my way to reattack. I just watched the aqula tub instal video and those guys took the retainer out the opposite side of the housing. I'll make that my last option. The cable is still attached to the transfer case and I'm not planning on removing it or else that would be a lot easier way to handle it.
 
Back
Top Bottom