Help please need auto electric

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Connected battery terminals in reverse. Some smoke near terminal. Check all relays, fuel pump,etc. fuel pump works, relays good. Engine crank but don't start. Fueses and relays good. Changed from different working cruiser. No spark at plugs. Has after market security but was off. Wondering if something shorted out when reversed terminals. Used volt meter to check distributor connection and brass bolt I'm fuse box. All good. Don't know where to continue troubleshooting.
 
You blew the fuseable links
 
Did a quick search...


This guy did the same thing, then the engine cranked but no start. Here's how the thread ended:




-----------------------------------------------------------

Hello Everyone: I just got the car back from my local Honda Specialty shop and it is now alive and well!

Here is what they have found to be problems:

1) The ECU was bad therefore no sparks from the plugs. And one of the four spark plug was dead.

2) Fuel Replay was bad therefore there were no fuel flow.

That's it! The Disbributor and Ignition Switch were okay. All the fuses and relays were fine. No problems with fuel pump or injectors. The total repair bill came to $306.64(including tax)! My brother was quite thrill to say the least. He almost paid that other CROOK close to $2,000 and it still wouldn't have fix the problem!

Anyway, I would like to thank everyone who particated and shared their expertise. In more ways than one, it was a good learning experience for me and my little brother.

Thanks guys!


--------------------------------------------------------------------




That's actually what I was going to say, the ECU got fried.

I threw the wrong switch on an old 12v/24v charger once and killed the ECU in a Camry. Put in a used computer module and all was well.






.
 
Last edited:
Others have swapped the POS & NEG terminals but the ECU didn't fry so there's a good chance that it is something simple.

@Max Thompson Does your check engine light (CEL) come on when you turn the key to ignition on, engine start mode?
 
With the key to run and no CEL indicates; no power to the ECU (most common), or ECU problem (rare), or bad bulb. The next test; with the key to run, check for power at the B+ terminal in the diagnostic connector on the firewall. If no power there, the problem is between there and the battery, EFI fuse, EFI relay, connection, etc.
 
What ^ he said!!!
 
Thank you very much. Today I take our afrer market security and change EFI relay and fuse and after this check engine light come on and fuel pump start work but still no spark on spark plugs.Please help
 
Did you do as ToolsRus suggested?

"The next test; with the key to run, check for power at the B+ terminal in the diagnostic connector on the firewall."
 
Ok, so it sounds like your igniter is not being told to energize.
 
Back
Top Bottom