Help once again

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I use them regularly! Sell them too!:grinpimp: What is your exact question?

Wondering about length? Thickness? Pitman arm compatability?

As far as length, they were designed for the standard 'inside' the frame' Saginaw box that uses the type of mounting plates orangefj45, poser and I sell.

As far as thickness, they are thicker than stock. Not a lot, but somewhat. Not as beefy as the heavy-wall tubes that some companies are offering with hi-steer kits.

Hth

Mark A.
 
65swb45 said:
I use them regularly! Sell them too!:grinpimp: What is your exact question?

Wondering about length? Thickness? Pitman arm compatability?

As far as length, they were designed for the standard 'inside' the frame' Saginaw box that uses the type of mounting plates orangefj45, poser and I sell.

As far as thickness, they are thicker than stock. Not a lot, but somewhat. Not as beefy as the heavy-wall tubes that some companies are offering with hi-steer kits.

Hth

Mark A.


I got orangefj45 plates. But my question was, Could I use any wrangler tie rod on downey drag link. becasue i have a wrangler pitman arm


Edit_ (does your friend still want does tires ??)
 
That I don't know. I'm not very familiar with heep parts.;p

You wanna measure the thread pitch and diameter of the shaft on your tie rod end and post up?
 
65swb45 said:
That I don't know. I'm not very familiar with heep parts.;p

You wanna measure the thread pitch and diameter of the shaft on your tie rod end and post up?


Well I think im going to go to downey and maybe see if there tie rod fits and see if the have anything for my output shaft
 
Well that's one way to do it!
 
Back
Top Bottom