help diagnosing elocker not working

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I'm not 100% sure but I'm fairly certain that if you do the hazard switch mod you DO NOT want to push the button while doing 50+ mph. Someone please correct me if I'm wrong.
 
There shouldn't be any issue with locking the CDL at speed. The system won't allow you to engage the axle lockers over 5mph.

The safety issue with the manual CDL switch (and being locked in high range) is that once you do engage the diff locks, it enables you to drive at highway speeds with the axles locked, which I was going to mention is very dangerous until wrongway around beat me to it.
 
I'm no expert on the use/application of locked diffs, but from my limited experience offroading with my locked 80, there are times I've learned not to use them- like where I have decent traction otherwise, going downhill, in tight turns. I can't imagine anything good coming from running locked (especially F/R) at much over 10-15 mph. Maybe for short burst of poor traction as speed, but if you can manage 50mph, being locked isn't going to benefit you, but certainly could cause a crash during an evasive maneuver.

BTW, my diff lock reliably even though my front flashes (bad position sensor), however, they usually don't lock until there is tire spin. I generally twist my switch as I'm approaching a spot that might need 4 wheels driving, and flip it off when I'm through.
 
Back
Top Bottom