Hello from Memphis

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 29, 2020
Threads
1
Messages
5
Location
Memphis, TN
New to Mud and the LC community. I’ve always wanted a LC of my own and yesterday was the day! 1994 w/202k on the clock. She runs great but won’t win any beauty pageants! My boys and I will have fun fixing her up. This page will be my go to for information! TIA.

DA400E57-19D9-45AE-9058-70962D101391.webp
 
Congratulations! Looks nice! Your boys will always remember the time they spend with you and the cruiser. Enjoy it!
 
welcome
 
Nice! I have the same year and color. I am a fan of the '94 for a number of reasons.

So how did they mangle the front door without damaging the running board?

Welcome!
 
Nice! I have the same year and color. I am a fan of the '94 for a number of reasons.

So how did they mangle the front door without damaging the running board?

Welcome!
I think the running boards were installed after the (poorly done) body work was completed from some kind of side impact... The door closes fine, but there's some definite wind noise coming from the upper window seal. I'll probably end up replacing the door before I get her painted.
Call me naive, but I didn't realize there's no OBD port on a '94! I've got a CEL and oil pressure warning light on, but oil pressure gauge isn't working (it's pegged out at the top). Engine runs/sounds fine and doesn't run hot, so idk. Currently researching possible culprlit.

Thanks for the warm welcome!
 
I think the running boards were installed after the (poorly done) body work was completed from some kind of side impact... The door closes fine, but there's some definite wind noise coming from the upper window seal. I'll probably end up replacing the door before I get her painted.
Call me naive, but I didn't realize there's no OBD port on a '94! I've got a CEL and oil pressure warning light on, but oil pressure gauge isn't working (it's pegged out at the top). Engine runs/sounds fine and doesn't run hot, so idk. Currently researching possible culprlit.

Thanks for the warm welcome!
Check to make sure the wire is connected on the sensor for the oil pressure.

There is an OBD1 port under the hood. You can use the paperclip to gather codes.
 
Back
Top Bottom