Heater core hoses 1F engine

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

GeoW5

SILVER Star
Joined
Jul 31, 2019
Threads
36
Messages
228
Location
Swansboro, NC.
on the 1F engine, what ports off the engine and return to the engine are used? i know mine is bypassed since the heater was disconnected. also what lower radiator hose is used since i am going to use an aftermarket heater and i dont think i will need the cast iron down pipe with the valve for temp control.
8B38BC93-6421-4982-A998-C784D7592EEC.webp
515D40B6-F1BF-46EE-9840-0ADB469AA9BB.webp
D4FFFFCA-B4CC-4F93-9623-F40D6DA1003B.webp
31143E69-D72E-4A46-9763-72008A261C78.webp
 
found a thread for you with decent pictures
 
found a thread for you with decent pictures
Thank you
 
Looks like the lower fitting in the block will produce the hottest water for the heater and thats what you'll need. I'm certain you've considered that.
 
I hadn’t as I wasn’t sure if that was to drain the block or for the heater. I guess I need to look at SOR for some images showing the routing. Having that hose come off the top and go to the front of the engine didn’t make sense either.
 
And that brings up another question. We generally use NPT for those type of threads in the USA. What type of fittings are used in this instance and where do you get them?
 
The factory didn't route the heater from the drain on the rear of the block, but from the top of the head, plus, it insures that the thermostat isn't working against the chore of defrosting the cab. Then the return from the heater will tee into to the lower hose at the radiator. A cable operated heater control valve is on the firewall, at least on later models.

There really isn't much of a metric pipe thread, in practice. The spark plug threads are metric, but they aren't tapered pipe. Even my metric set of rethreading taps and dies comes with a 1/8" NPT. My aftermarket radiator uses something like an 8 or 10 mm straight-thread with a gasket; it serves the use for plumbing, but the thread is essentially a standard machine screw.
 
Well crap. I was hoping to use a one piece lower radiator hose and discontinue using that steel piece. I am going to use an aftermarket heater inside the cab w an electric heat control in that unit.
 
Back
Top Bottom