Guess its time for Longfields

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

ArmyFJ

Lookin’ for mud in all the wrong places.
GOLD Star
Joined
Mar 3, 2006
Threads
82
Messages
733
Location
NOVA
Well I was doing my front axle service and I was trying to separate the short side (still not budging even after the pipe trick.) when I noticed the splines looked funny.

IMG_0114.jpg


IMG_0112.jpg


IMG_0111.jpg


Any one use Longfields on the DD? I DD my rig but run37s...choices choices. But I have heard they wear faster...

Matthew
 
I am not sure if I am going to just get OEM or not...I do DD 40 miles a day. I am sure that would not be great on the Longfields...
 
Noticed this too....

It should be more or less square comparing it to the driver side.

IMG_0117.jpg


The brass bushing in the spindle is worn out on both sides but I am guessing it manifested on the passenger side by cleaning out a nice chunk in the bell and eating some of the flange.

Matthew
 
That spline wear is common on the early trucks. The later trucks and all replacements have longer birf splines and thicker drive plates.
 
Just curious, how did the bell get that damaged? Is it due to the birf flopping around from bad drive flanges and spindle bushings and rubbing on the axle housing. did it tear anything else up? I would go with the longs since you got them big ol tar's
I would go with the longs for my 33's but I like overkill:cheers:
 
I still need to check it I just found that and the knuckle is still messy.
 
Ive had my longs for a couple of years now. I've probably put about 30,000 miles of daily driving on them with no problems to date. I did do the part time kit about 10,000 miles ago. So my longs really have about 20,000 on them. I know Bobby does not recomend them for daily drivers though. I guess it depends on how you wheel your truck. I assume that with 37's you wheel hard enough and could certainly use the reliability of the Longs. You could always do the part time kit to save the longs if the drawbacks (of the part time kit) are worth it to you.
 
That spline wear is common on the early trucks. The later trucks and all replacements have longer birf splines and thicker drive plates.

I wouldn't say common, just not unheard of. Some of the early ones were not lubed from Araco and have accelerated wear. Poor maintenance just compounds it. I still have the originals in mine and the splines looked new last time out.
 
Well I am going to run the long splined birfs from Chad. If they break then I will go to Longfields. I am pretty light on the throttle, and I don't have a locker up front. Maybe by the time I need Longfields there will be an Orion Box for an 80.
 
Back
Top Bottom