green plug on 78 carb

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 17, 2003
Threads
30
Messages
257
Location
South Pierce County, WA
Looks like it goes to an idle solenoid?? Do I just need to wire in a switched power source? Anybody got an extra male side plug (wiring harness side) for this? It's going in my 66 FJ40. Thanks. I can email pics for clarification if my attempt at posting them here doesn't work.
 
Last edited:
OK, that black with yellow stripe wire is over on the pass side uder the vacuum switch. Is that the one? I thought that would be needed by the igniter. Should I splice into it further upstream or just make a new one? I installed an aux fuse panel that comes off ignition switch for power...I hope I got it right! Could come off that?
 
Last edited:
here my .02 worth, i call it an anti-diesel valve, just to keep the engine from dieseling when shut off, take it out, take a good pair of dykes and cut the end off of that useless bastard! Thats what I did to mine, runs fine. I been de smogging rigs for years, if you get all the useless crap off, and and an engine is tuned right, then you wont need the valve. might not do this in california though.
 
thewatergoblin said:
here my .02 worth, i call it an anti-diesel valve, just to keep the engine from dieseling when shut off, take it out, take a good pair of dykes and cut the end off of that useless bastard! Thats what I did to mine, runs fine. I been de smogging rigs for years, if you get all the useless crap off, and and an engine is tuned right, then you wont need the valve. might not do this in california though.

Sure sounds like a good plan. I like things simple. I'm just not confident enough to start cutting stuff up just yet. Might as well try to make it all work if I can. Thanks for the backup plan tho!
 
thewatergoblin said:
here my .02 worth, i call it an anti-diesel valve, just to keep the engine from dieseling when shut off, take it out, take a good pair of dykes and cut the end off of that useless bastard! .


No No No No

While the fuel cut off solenoid does indeed help prevent dieseling, if you cut the wire it shuts off the fuel, so it own't idle either. If yours idles with the wire cut, you have carb problems.

Amanda,

Just hook it to any black wire with yellow stripe. They are all the same. You can run a wire from the hot (+) side of the coil.
 
Thanks, I'll make up a wire to the + post on the coil. Am I correct in thinking the black with yellow stripe wire in the photo(coming out of the firewall) goes to the short plug on the igniter? Problem is the igniter plug has two wires...do they both splice to switched power?
 
No, im not saying cut the wire, that will definetly shut the fuel off, Im saying cut the end off of the valve itself, on the end of the threaded piece that fits in the carb, cut as close to the body of the valve as you can, just snip the piece off that actually shuts the fuel off.
 
Back
Top Bottom