Going Deep

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 18, 2016
Threads
69
Messages
339
Location
Chapin, South Carolina
Pulled the oil level sensor to replace the o ring, and started on the oil pan. Any suggestions on making sure I don't end up with another leak after creating the new seal? Oh yeah and I found a compressor leak, does it stop? Lol

image.webp
 
The common practice the journeymen mechanics passed on to me was to just rtv a gasket to the pan / cover / removable side part & smear a bead of grease on the block side of things - lets you position the gasket & wait for it to cure slightly / tack - and the grease side lets it seal but also if you go back in for any reason you stand an excellent chance of being able to save the gasket since it's glued to the part coming off.

A quick smear of more grease & 90% of the time no need to either buy/find/cut another gasket.

Works for cork, mineral paper, & rubber gaskets.

A quick tap with a mallet (if even that) & covers pop loose.

It seems a common practice for refinery machinery, I carry over the same practice to the motors I've worked on - mostly VW motors prev & a couple V8's - and obviously a certain I6 we all are familiar with -& I've never had issues.
 
You just use fipg no gasket on 1fz, run two beads and stick it up with couple bolts ready you wanna see it smush out do it with in 15 minutes and I only use the Toyota fipg black for oil, make sure pan is square if not take hammer to it and massage back into square or it will not seal
 
Back
Top Bottom