GM steering column question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 7, 2003
Threads
32
Messages
138
Location
Southern Oregon
I want to replace my column when I convert to power steering. I have a GM column (86 Camaro). My concern is the distance between the column and the brake pedal. I have about a 1/2 inch. The GM column is noticibly larger in diameter. I searched and haven't seen this addressed. Do you guys bend the brake pedal over slightly?
 
i'm dealing with that now that i've finally decided to put both bolts in the dash bracket...i'm just going to shift the column about 1/2" toward the right. i've run with one bolt the column angled for four years. :D
 
I had zero clearance issues I just removed some of the plastic housing up to the spot where it tilts and then it could mount tighter up to the dash and it doesnt rub on anything. I also modified the original gm mounting bracket so it sit up about an inch higher. so it sits at the same hight as the stock unit did

tilt is great for getting in and out of the rig esepcially cuz my seats are hard mounted.
 
Last edited:
I did the same thing Greencruiser did jus welded tabs on the stock column housing bracket and mounted it as high as I could
close but no contact
 
Mine had a tiny bit of contact with the brights switch. I think that was the one it was. And was pretty much only because of how low I had it mounted through the firewall. I also had to tweak on the rods that push the ignition switch part and the brights.

-Dustin
 
i cut the notch in the dash under the gauges a little wider and shortened up the chevy bracket so it fit. and then at the firewall i removed the factory bracket and made my own and put the colunm up as high as i could and have no clearance problems at all.
 
Back
Top Bottom