Getting the rig put together

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 5, 2006
Threads
6
Messages
131
Location
San Ramon, CA
I have posted before, so am not quite a newbie, but I have not posted any pictures of my truck. It is a 1994 FZJ80 with factory lockers, flareless, with an OME heavy lift front and rear, Slee Shortbus front bumper, 4X4 Labs rear bumper, Metaltech sliders, Slee skid plate, CDL switch, 7-pin mod. It usually runs 285/75 Big O ATs on stock rims but I also would like to run some bigger, more aggressive tires for offroad. I recently needed new wheels and tires for my 1970 sprung over 40 so decided to get wheels and tires that would fit both the 40 and the 80 if I wanted to have some bigger tires. I ended up with 16x7 black rockcrawler rims with 4 inch backspacing with 35x10.5 Super Swamper SSRs. The tires are actually 35.5 inches in diameter so are about the size of many 36 inch tires. They fit well and look good on both vehicles. The bigger tires and steel rims are quite a bit heavier than the stockers and with stock gearing do slow the 80 down a bit on the street. I also get one MPG less with these tires than with the 285s.

David Sword
P5190012-1.webp
P5190014_edited-1.webp
P5190018-1.webp
 
looks tough...
 
Awesome looking rig. What did you use to fill your holes where the front flares were? Looks like little caps or something? I'm tired of looking at my holey front end.
 
Awesome looking rig. What did you use to fill your holes where the front flares were? Looks like little caps or something? I'm tired of looking at my holey front end.

I got some plastic plugs from OSH. I want to get it speedy lined at some point.

David Sword
 
Back
Top Bottom