Gasket changes tranny and tcase, difficult?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 1, 2006
Threads
447
Messages
1,858
Location
Dallas
Website
www.octagonmma.com
I wanna do my own and just got the new ones ordered from Kurt @ CO. Should I do them to save some jack or just let the transmission shop do them? They have the tranny/tcase already. Just trying to think ahead............
 
I wanna do my own and just got the new ones ordered from Kurt @ CO. Should I do them to save some jack or just let the transmission shop do them? They have the tranny/tcase already. Just trying to think ahead............

I think you will $ave a lot and learn a lot by doing it yourself, if you have the time and a place to do it.

Ed
 
I wanna do my own and just got the new ones ordered from Kurt @ CO. Should I do them to save some jack or just let the transmission shop do them? They have the tranny/tcase already. Just trying to think ahead............


What's your stuff in the shop for?

If you've already agreed to have them fix your trans and/or transfercase they'll do the seals as part of a repair, and won't want to warrant their work if you don't let them complete the job.
 
I'm about to start this job and add on more stuff as I go. I want to take off my tranny hump but every bolt head is unrecognizable, So i'll have some grinding to do. I figure my cruiser will be out of commission for at least a month at the pace im going. Tell us how it goes. I think I might do a clutch, main seal, oil pan gasket, side cover gasket, valve cover gasket and all the gaskets on the xfer and tranny case. Oh yeah paint and fix my seat brackets put some rust bullet all around my gas tank. Paint under my gas tank. What are your plains?
 
If you're going to repalce the gaskets you might as well have all the entire case rebuilt. You'll have to repalce a bearing so you'll need a press.

Yes you'll learn if you were to do it yourself, but it can be very time consuming and frustrating. I paid someone to do mine after I removed it. It was only $150.00, plus the cost of the kit.
 
Back
Top Bottom