Gasket between tranny/t-case

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 1, 2004
Threads
267
Messages
8,476
Location
Northern Colorado
I'm taking the two apart to replace the seals and such...but.....

that gasket between the two is no good...really thin paper gasket...no one even shows one in their book...the dealer thought they had a number for it, but they weren't really sure....

what does this gasket do? and could a make on from the gasket sheets to replace it since nobody even has it listed???
 
Yes, you can make one but use the very thin paper like gasket material. You want to be able to keep those 5 bolts tight and torqued. Something thicker will probably compress over time and bolt torqued will be reduced.

I've also used silicon and had good results. Ultra Black. Does not need to be thick or even cover the whole area the gasket covered. Just make a 1/8" to 3/16" thick bead around the bearing on the t-case about an inch away from the bearing then install t-case and torque bolts. I also use red locktight on the 5 bolts.
 
Back
Top Bottom