- Location
- United States
I have an H55F with a deisel input shaft. I need one of the gas variety... Do any of you have one of these laying around? Thanks, SDC
Wanted Gas H55f Input Shaft
- Thread starter SuperDuperCruizer
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Is yours for the "B" engine? If so don't toss it out. I'll pick it up when I'm around in the summer (I'll be all over the states this summer '06).
You lookinf for new or used? I don't have used ones, but I should be able to get a new one (have ordered several in the past). LMK
- Thread starter
- #4
I was keeping the B-diesel Input for another project...
I was hoping to score a used 6-cylinder input shaft for another project. Perhaps someone bought a 5-speed and swapped out the 6-cylinder unit for a B-series input shaft. Anyone? What does a new one cost?
I was hoping to score a used 6-cylinder input shaft for another project. Perhaps someone bought a 5-speed and swapped out the 6-cylinder unit for a B-series input shaft. Anyone? What does a new one cost?
SuperDuperCruizer said:
$250 new
- Thread starter
- #7
Sorry...
Dave, it's from a 3B. Is the HZ input the same as an H & F input shaft? I was under the impression that all the 6-cylinder inputs were the same. ????
Dave, it's from a 3B. Is the HZ input the same as an H & F input shaft? I was under the impression that all the 6-cylinder inputs were the same. ????
1HZ input is about 1cm longer that H/F input and has 21 splines. B inputs are 21 splines but much longer.