FZJ80 Leaking All Over

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 1, 2016
Threads
19
Messages
229
Location
Utah Valley
I've got several leaks on my FZJ80 and would really appreciate some help pinpointing exactly what they are from. Excuse the crappy video and me being a total :banana:. Just thought a video might help you to better see the problem areas. Thanks!

(you can also see the axle seals are SHOT. Doing all that this weekend, as well as all 4 shocks as those are pretty much done)

 
Aside from the leaks it looks pretty good underneath. I would definitely be greasing your prop shaft slip yokes. One of the weeps looks like a rear main seal which is standard. It's a pain to change but it's not the end of the world. You can also leave it awhile. If you are tight for money you can use Lucas Stop Leak but I would not recommend it. It swells the seals for 6 months to seal them but when it loses potency the seals leak worse than before. Plus you run the risk of damaging non leaking ones.

Oil pan is an easy job. I'd say check your valve cover gasket's too. 1 thing at a time and don't let it get you down. The 80 is unkillable.
 
Also, change the oil and swap to a thicker grade. When I bought mine the PO used 10/30 synthetic that made things leak like a sieve. I fixed everything except the rear main and it only a slight drop now.

Stay away from any stop leak stuff especially for the radiator.

Time to turn your 1 banana to 3+
Since the holidays are coming up sears has sales. Buy the tool set online and do pick up. PM me if you need more info.


Whenever I buy a new to me car I start first by cleaning the whole engine and undercarriage and go from there. There is good people here to help you out.

I rebuilt knuckles, installed lifts, ect, for mudders on here for beer, lunch and gas money.
 
how does one do that?
Get a grease gun. Research before you buy one. Some are s***ty and some are good.

Don't over grease the zero for the splines. Can hydro and put too much pressure on the output bearings of the T case.

Spend some time and go through the FAQ and search here. Then get opinions.

Set aside about $1k for maintenance.
 
Oil pump cover gasket (o-ring), front main seal, valve cover gasket and distributor O-ring all look to be culprits. Fixing those will probably get you close to 100% leak free. Check spark plugs, see if they are wet with oil around the threads, if so, you can buy some spark plug tube gaskets. That video you posted is a good DIY for the oil pump cover. Buy new Philips head screws too.

The rear most leak on your transfer case is the speedometer O-ring. I just was about to buy one myself, so PN is: 96711-24030
 
Reseal both upper and lower pans. To remove upper pan, you have to loosen the engine mounts to take upper pan out and reinstall by lifting motor by few inches.
 
Back
Top Bottom