Full Width Axles?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 2, 2004
Threads
81
Messages
602
Location
Western Slope, CO
What modifications would be involved to run Axles from a 77 Ford 3/4T? I believe that it has the hydraulic ram assist steering(don't know much about this set-up)heard people say this was not a good steering system for Ford. Could you run these axles with a stock drivetrain? 350 conversion? Also has anyone put a 460 in a 40? :confused: :D
 
I only ask because I can get a complete truck for free....ok sell it and get what I need huh?
 
It will have the front pumpkin on the drivers side .If it is a high pinion you could get $$$ for it . sell it and build the most killer frnt cruiser axle drop in a 350 chev ,ford big blocks are too wide!
 
I am thinking that you will have a 30 spline rear axle, a closed knuckle front 44 and a bunch of other stuff that you will nto like much.

But I could be wrong.

I have FS 1 ton stuff in my rig. It works okay :)
 
Yeah, I like my cummins where its at....pulls my 40 just fine :flipoff2:
 
Back
Top Bottom