Fuel line

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 15, 2005
Threads
4
Messages
123
Location
Arlen, Texas
What kind of fuel line does everyone use? Anything besides that cheap standard NAPA stuff I have been using. I by-passed all my orginal linesa dn ran rubber fuel lines for everything. Only problem is, every 12 -18 months the ends crack and it starts leaking and I have to go in and re-splice the ends or replace the whole mess. I'm looking for something, anything that will last longer than this. I have been changing these hoses out for the last 7 years. My orginal hard lines are still mounted, but they were by passed because I had all kinds of junk in my tank and I had no idea what was in those lines. Anyone have a trick to cleaning these lines out? I would love to go back to the original hard lines and just replace the soft lines that are in those runs. Any help would be great. Thanks.
 
Pull the hard lines off, seal one end then stand them up and fill them with carb cleaning solution. Let soak 24 hours flush, blow dry, paint the outside if needed and re-install them. The carb cleaner will remove any thing on the inside.
 
That sounds like a good iead. I was thinking of some more in the line of a real small wire brush and I could attach to some wire and run it through and pull the brush in behind the wire and kind of scour and clean the inside after a couple of passes with the brush. Then a good compressed air cleaning. After looking at them close yesterday, they don't look real bad from the outside, but who knows what's going on inside since they have been open ended for about 7 years now.
 
I'll have to see if I have one small enough. I must have 10 of those gun cleaning kits around here somwhere. Everytime I go to clean a gun I can't find one and go buy another. There has to be something small emough or I can run over to Academy and buy something.

Bad thing is I got a run to do in the AM and I am here at work trying to figure out the best quick fix for it today so I can head out first thing Sat. I guess I will cut the ends and re-splice the old hoses and cross my fingers that they don't crack anymore. Do they make a better quality fuel line than the standard rubber NAPA type hoses?
 
You could also replace the steel lines. A handheld tubing bender is pretty cheap and a handy tool to have. You can buy straight lengths of brake line in several diameters.

If you go with the brush, one way to get a string through the tube is to feed it into one end while sucking on the other end with a vacuum cleaner. Then tie stronger line on and pull it back through, tie on a brush and some more stong line and pull the brush back and forth, etc. HTH
 
Bending some new pipe might be the best option. I can get my hands on a bender for free I think, but they sure make some funky turns. I guess I don't have to follow the original lines exactly. I'm thinking it's the heat. The rubber lines close to the engine fail first, which is what I'm replacing today. I had to go and order some line, but they will have it dropped shipped this afternoon so I can go ahead and replace it all today and fix it right with the hard lines later. I need to find that hard line that runs in front of the engine over to the carb from the fuel pump. I tossed it I think when I went with a Webber. I wonder if Toyota still sells them or if someone knows where a cheap used one might be?
 
Rusty,
Did you ever find a good replacement for your hard and soft fuel lines? I'm putting a new tub on my '79 and figured I might as well update the fuel system while its easy to get to.
 
Thin piano wire comes in large lengths. (I've had a spool I've used/cut small piecies off to clean passage ways for many years) Push through, bend a hook and place a patch, like a gun cleaning patch, soaked with carb cleaner, pull back through...
 
Back
Top Bottom