Fuel gauge calibration/accuracy

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 27, 2005
Threads
88
Messages
929
Location
Northern California
Website
www.facebook.com
Hello, when i fill my tank(complete) my fuel gauge registers 3/4 full. How do i get this to the full mark. Is there a fix or calibration technique? I usually fill back up when it's at approx.1/4 full.It usually takes about 10 gallons. I know it's a 22 Gallon tank(83 BJ42). Needle doesn't fluctuate while driving. Could it be the sending unit or float bowl? Anyone had this problem. Looking for the fix. Thanks in advance.
 
Sounds like a poor sender to me...


Remove it, and test it with an ohm meter....that will tell you what is going on with the sender.

The operational peramiters for the fuel sender can be found in the factory service manual, chassis and body.


Good luck!


-Steve
 
New registered user, former lurker here!

I have a 79 FJ40 and my fuel guage does the exact same thing! thanks for the pointers there. I am going to check it out. (gonna finally use my Haynes for the first time!)

Beige 79 FJ40
45K original miles
Stock all the way!
 
Back
Top Bottom