Front Turn Signal Removal..I feel stupid

[Jukelemon]

Hi all.

This has got to be the most simple question I have ever asked in regard to my truck.

My front turn signal is out. I removed the two screws BUT it is acting like there are more. I do NOT want to break the dang thing.

OK....flame on....what is the secret ( :

Thanks all.

 

[KLF]

I don't have a truck like that nose style anymore, so I can't take a look, but I seem to remember it can be hard to pull out once you remove the 2 screws.

I believe there are instructions in the Owner's Manual. Do you have one?

 

[ToyotaNick]

i know that on my truck the turn signals are the rectangular lights in the bumper and those come out very easy but the marker lights on each side of the head lights are a little harder... once you remove the two screws you have to pry it off of the grill because it has two prongs that slide into plastic sleeves in the grille. i just used a screw driver. there normally in there really good and it takes a good bit of pullin to make the sleeves let go of the prongs

 

[Jukelemon]

Thanks all. It was in deed the marker lights not the turn.

I figured it out a couple hours later. You were right though-you have to pry the end off. I used the chrome surround/trim as the pry point because I just knew I would break the 17 year old plastic lens.